Al Gietzen wrote:
Now the reason why.
The lower hose from the water pump blew off. The reason was that I
had
fitted a thick walled pipe from the engine to the pressurised overflow
bottle. The bore
of the pipe was too small to take a large flow of water as the
engine
heated up.
Ian;
Very sorry to hear about your accident.
I'd be interested in knowing how large the pipe was. This gets
attention
because I installed a 1/4" aluminum line as an overflow pipe from the
pressure cap to the overflow bottle, and thought later it may be too
small.
It doesn't jeopardize the system because what the line can't handle
would
escape through the upper gasket of the cap; but it would make a mess and
result in some coolant loss which wouldn't recover on cooldown.
Al
Hi Al
Ian Beadle wrote:
The pipe was 6mm (1/4inch) with 2mm wall which left just 2mm bore. Not
enough. Your alloy pipe is probably 1 mm wall, which leaves you 4mm bore.
Enough? Any good at physics? If you treble the temperature of a volume of
water, how much extra volume do you have?
Ian Beadle
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.