Subject: Peripheral Port all aluminum rotary
From: ACRE
Date: 4/26/2004, 10:54 PM


     I am
     > going to make my ports a little wider (1.75") horizontally.   Enlarging
     > horizontally  does not effect timing.   I am doing so to slow the inlet
     > charge down.   According to Rolf's analysis,  is important to limit the
     > velocity of  the intake mixture to less than 0.5 mach.  Above that,
     > the engine will start to choke.

Be careful on width Jerry. The tip seal must span the gap of course,
so a tough stiff seal is called for. Probably a metal seal being best.
What are Tracy's new seals made from? Two stroke piston engines
used to have a problem here as well, catching rings on a "too wide" port.
We are shooting for long term durability here. Racers will do rebuilds
much more often than we want to.
Bill Jepson

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.