Subject: Peripheral Port all aluminum rotary
From: ACRE
Date: 4/26/2004, 10:32 AM


Perry,  According to Mederer, his p ports are too large for a 6000 rpm
engine.   One can have either too big or too small ports depending on
RPM.  This is not an extremely sensitive issue requiring great
precision.     I can tell  you that my 1.5" dia.  ports which are fine
for 6000 to 7000rpm, will run out of capacity at 8000 rpm   according
to calculations I just received from Rolf Pfeiffer.    However, they
are easily modified with a die grinder if higher RPM is planned.  I am
going to make my ports a little wider (1.75") horizontally.   Enlarging
horizontally  does not effect timing.   I am doing so to slow the inlet
charge down.   According to Rolf's analysis,  is important to limit the
velocity of  the intake mixture to less than 0.5 mach.  Above that,
the engine will start to choke.

  Large ports, on the other hand,  have exhaust overlap issues that I am
guessing become less significant as the rpm increases but are
undesirable if they can be avoided.     Rolf has sent me an insightful
analysis of  PPort sizing and timing that I will post if he gives me
permission.   All of the "expert" sounding comments you hear from me on
this subject are learned from him.   Rolf,  may I  post your data and
comments?

As far as boring the housing is concerned, I don't think  you have to
worry about it.  Just take the housing to a good machinist.    I  have
done it once on a practice 12A housing, and it was not a problem.  If
you check my insert drawings  you will note that  the ports are located
  in inches from the housing center line.  Makes it easy for the
machinist.  I will be doing a practice 13B housing next week.  I will
report back on how it goes.

   Jerry  (not a machinist or engineer sadly)


With the recent fad of 2.85 drive and 8000 RPM, would the RB PP be more
suitable for that?

Perry

Not a fad :) The future!

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.