Al Gietzen wrote:
Ian Beadle wrote:
The pipe was 6mm (1/4inch) with 2mm wall which left just 2mm bore. Not
enough. Your alloy pipe is probably 1 mm wall, which leaves you 4mm bore.
Enough? Any good at physics? If you treble the temperature of a volume of
water, how much extra volume do you have?
Ian Beadle
I did a quick test and found that 1 pint of water ran through a 1/4" tube
(1/8" i.d.) in about 30 seconds with a gravity head of about 2 ft (about 1
psi); so I think a 1/4" tube ought to be fine for normal thermal expansion
of the coolant. The thing it wouldn't handle would be some boiling coolant.
Al
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.