Kevin & Kim wrote:
Right.
A quickie at lunchtime....
I was looking at RacingBeat's site and their aluminum parts.
http://www.racingbeat.com/resultset.asp?PartNumber=11061
Here's some ideas swirling around in my head:
Why can't a guy do that on a limited scale for himself and a few friends?
Well, with the help of a local foundry and a machine shop. I know it would
be expensive, but would the end result really cost $1200 per part?!? (Yeah,
I went to business school and understand the notion of cost/profit... My
bigger problems is that I should have gone to engineering school.
Anyway...)
Here's the setup I am imagining: Please feel free to shoot this down at any
point.
1. Use old 13b parts for slurry/sand cast models. Parting lines can be at
the flat sides.
2. Rotor housings can be modified if needed. If the inner wall needs extra
material, that can be added with a strip of .030 sheet (or whatever size
needed) adhered to the inner surface.
3. Pour castings
4. Clean and Heat treat
4.5 (if desired) - send out for cryogenic treatment to releive internal
stresses.
5. Sides and seal areas can be planed/ground flat as needed
6. Build a grinding/honing machine using an e-shaft and rotor. Substitute
apex seals with honing/abrasive surfaces and turn at a slow speed. Shaft
and rotor may also oscillate up and down if wanted.
7. Ends can be machined flat and ground as needed. Lapping can be done with
abrasive paper adhered to a sheet of glass (a trick learned from my fibre
optic days - US Army).
8. Surface Coat. Here's where it gets' tricky. I know Racing Beat uses
FlameSpray of some sort. I ran into this while searching for coatings for
aluminum injection molds. http://www.armoloy.com/are.html
Their Chrome coating has a Rockwell hardness of 78 Their diamond coating
has an alleged hardness of 98!!! (HOWEVER, I have no idea how abrasive that
may be. Diamonds make wonderful cutting surfaces.)
9. Assemble engine with factory e-shaft, aftermarket bearings and seals,
lightened rotors. Use apex seals of choice.
Should be lighter and less than $8000 (well, truthfully, I have no idea how
much Armoloy charges for a diamond coat.) But, end housings could be cast
that way. And with a bit of volume, (buddies, an entrepreneurial spirit,
etc.) cost should be driven down.
AND, since the whole shootin'-match is aluminum with a chrome coating from a
bath process, coolant galleys shouldn't develop corrosion and/or rust and
whatever else.
Oh, and I don't see ANYTHING here needing to be CNC machined. Old-fashioned
machine shop tools should do whatever job is needed. Mating surfaces need
to be flattened and trued, but that's not too difficult. Using an e-shaft
and rotor to true the epitrochoid would (should?) create a uniform surface
on the internal raceway (especially with a fixed cutter or diamond hone, not
spring loaded).
Now my disclaimer. I wonder if I'm barking up the wrong tree by wanting to
cast a rotor housing without a steel inner sleeve. A surface coating of a
few microns may not last very long. Perhaps a new factory rotor housing
would be cheaper all together.
Comments? Suggestions? Problems?
Thanks for letting me use my lunch time in this fine house of fellowship.
Kevin
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.