Bill, 1.75" is not wide by p
port standards. The racing beat p
ports
are over 2 inches wide.
Jerry
That sounds reasonable Jerry.
Just want you to be safe. I like the
P-
port
engine because you can do a
simple flat sideplate. It would seem
like
the
easiest way to do a custom job.
Bill Jepson
"Powell, Ken" wrote:
Why not move the port over
horizontally a little to keep the port
edge
away from the side piece of the apex
seal? In other words, offset the
port so it is not in the center of
the housing. And yes Jerry, PPorts
are still my plan - however, I am
pretty sure that I'm going to use the
side ports as well, especially in an
effort to improve the idle. My
latest thoughts are that I would use
separate throttle cables for the
side ports vs. the PPorts so I can
close the PPorts completely while in
the landing phase and use the side
ports for low speed throttle control.
I'm still not sure how well this
will work because the Pport will allow
more exhaust gas dilution which will
surely degrade the idle.
Ken Powell
To all P-Porters, ( sounds ominous)
It would seem that the weak link with
the P-Port is it's actual size and
that effect on the apex seal.
I was wondering if a number of smaller
inlet holes would better suite as
this would remove the apex seal
potential problem (as does a bridge post
does for the side seals).
I've noticed even some bridge ports use
the drilled hole approch rather than
the machined slot.
George (down under)
Just a thought. Would ports like the high
rpm ports on the six port engine (wow
that's a lot of ports) work in combination
with the P-ports but instead of opening at
hi RPM they could open as the RPM's get
lower allowing for a transition between
the p-port closing and the side ports
opening and vise versa.
Allen Ervin
scorpion472@comcast.net
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.