Subject: Peripheral Port all aluminum rotary
From: ACRE
Date: 4/28/2004, 7:00 AM


<< Bill,  1.75" is not wide by p port standards.  The racing beat p ports
 > are over 2 inches wide.    Jerry
  >>

Be sure to use the full span seal with the small corner piece.  The three
piece, and the two piece with the wide corner piece are no good for the Pport. A
slight arch to the top (closing) with a shallow chamfer and polish all around
the port will assure long life. A centrifugal load that could bow the center
of the steel seal into the port opening would remove the chrome in short order.
In a 9,500 RPM race engine it could be a problem, but I don't think it will
ever come up below 8,000 RPM.

There is a huge testing staff out there every night on the parking lots of
America incinerating the rear tires on thousands of rotary powered vehicles.
They have a thing called drifting, where you race around pylons like an
autocross, but the turns are so sharp that you have to keep the wheels spinning to
complete the turns. If no lot is available, they have drag racing line locks on
the front wheels, so they can hold the front brakes on and spin up the rears in
a burnout contest. Just who can make the biggest mountain of smoke.

They have found the weak spots, and they are not anywhere near what is called
for in aircraft service. These kids are running turbo boost off the scale
with nitrous on top of that.

One of these guys put a switch in line with an injector just to see if
Tracy's apex seals would hold up in full detonation at high boost. The seal cracked
but didn't damage the engine. These kids have more money to spend in a week
than I did in a year at their age.

Lynn E. Hanover

Lynn, was that cracked Tracy seal a 2 mm or 3 mm version?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.