Subject: Peripheral Port all aluminum rotary
From: ACRE
Date: 4/28/2004, 8:34 AM


Bill,  1.75" is not wide by p port standards.  The racing beat p
ports
are over 2 inches wide.   Jerry

That sounds reasonable Jerry. Just want you to be safe. I like the
P-
port
engine because you can do a simple flat sideplate. It would seem
like
the
easiest way to do a custom job. Bill Jepson

"Powell, Ken" wrote:

Why not move the port over horizontally a little to keep the port edge
away from the side piece of the apex seal?  In other words, offset the
port so it is not in the center of the housing.  And yes Jerry, PPorts
are still my plan - however, I am pretty sure that I'm going to use the
side ports as well, especially in an effort to improve the idle.  My
latest thoughts are that I would use separate throttle cables for the
side ports vs. the PPorts so I can close the PPorts completely while in
the landing phase and use the side ports for low speed throttle control.
I'm still not sure how well this will work because the Pport will allow
more exhaust gas dilution which will surely degrade the idle.

Ken Powell

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.