Subject: Peripheral Port all aluminum rotary
From: ACRE
Date: 4/29/2004, 8:08 AM


Bill,  1.75" is not wide by p port standards.  The racing
beat
p
ports
are over 2 inches wide.   Jerry

That sounds reasonable Jerry. Just want you to be safe. I
like
the
P-
port
engine because you can do a simple flat sideplate. It would
seem
like
the
easiest way to do a custom job. Bill Jepson

"Powell, Ken" wrote:

Why not move the port over horizontally a little to keep the
port
edge
away from the side piece of the apex seal?  In other words,
offset
the
port so it is not in the center of the housing.  And yes Jerry,
PPorts
are still my plan - however, I am pretty sure that I'm going to
use
the
side ports as well, especially in an effort to improve the
idle.
My
latest thoughts are that I would use separate throttle cables
for
the
side ports vs. the PPorts so I can close the PPorts completely
while in
the landing phase and use the side ports for low speed throttle
control.
I'm still not sure how well this will work because the Pport
will
allow
more exhaust gas dilution which will surely degrade the idle.

Ken Powell


To all P-Porters, ( sounds ominous)

It would seem that the weak link with the P-Port is it's actual
size
and
that effect on the apex seal.

I was wondering if a number of smaller inlet holes would better
suite
as
this would remove the apex seal potential problem (as does a
bridge
post
does for the side seals).
I've noticed even some bridge ports use the drilled hole approch
rather than
the machined slot.

George (down under)


George,  I don't think there is a a seal issue with p ports unless
they
are quite wide and/or shaped so that the seal is slamming into a
horizontal ridge.  If the port is narrower than the seal and the
upper
edge is curved, then I, think, no problem.  P ports have been around
for a long time.  Attached is a drawing of the shape I am
considering.
Starts with 1.5" bore insert.  Opened up with die grinder.
Jerry

Paul Lamar


Jerry,
Why open the port liner with an area larger than the throttle body or
the intake tubing?  Example: why have an area of 2.75 sq. in. opening
into the combustion chamber when the throttle body is only 1.767 sq. in
(1.5" dia)?  This would appear to only lessen the apex seal support
while not increasing flow (the restriction is the intake tube diameter).
Here are a couple of pictures from Lynn H.

Ken Powell

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.