Subject: Peripheral Port all aluminum rotary
From: ACRE
Date: 4/29/2004, 10:56 AM


Jerry,
Why open the port liner with an area larger than the throttle body or
the intake tubing?  Example: why have an area of 2.75 sq. in. opening
into the combustion chamber when the throttle body is only 1.767 sq.
in
(1.5" dia)?  This would appear to only lessen the apex seal support
while not increasing flow (the restriction is the intake tube
diameter).
Here are a couple of pictures from Lynn H.

Ken Powell

Good point Ken.  The insert bore tapers down to the 1.5" dia  butterfly
in both directions. To flow smoothly from the intake tube, both will
have the same o.d./ i.d. where they meet,   and on the housing side the
expanding ramp to the  port will "help" the flow into the combustion
chamber.   That is how I imagine it will work.  Truth is,  according to
Rolf, the 1.5 dia  port is very adequate for a 6000/7000 rpm machine so
I probably don't have to make the port wider at all.  But the 1.5" port
will run out of capacity at 8000 rpm and so it will not be adequate for
those using the 2:8 drive.  Why not just make a 1.75 dia  bore insert?
The height of the opening  screws up the I.O.  Using the 1.5" butterfly
and opening up the port  horizontally seems to be a good all around
solution.  I am still changing my mind on these issues as I learn more.
   Jerry

The butterfly will also add restriction Jerry.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.