<< To all P-Porters, ( sounds ominous)
>
> It would seem that the weak link with the P-Port is it's actual size and
> that effect on the apex seal.
>
> I was wondering if a number of smaller inlet holes would better suite as
> this would remove the apex seal potential problem (as does a bridge post
> does for the side seals).
> I've noticed even some bridge ports use the drilled hole approach rather
than
> the machined slot.
>
> George (down under)
>>
I don't think there is a big problem with port size so long as you use the
apex seal with the full span main piece and the triangular corner piece. Above
the factory red line the steel based seal may not track the rotor housing
properly because of it's weight. But those combinations are raced every weekend
with added spring pressure and revved to over 9,000 RPM. That is in SCCA E
Production racing and there are over 100 cars out there every weekend in that class,
and hundreds in another called Spec RX-7. There are very few failures.
But if you just want the long term wear possibility of the big port to be
minimized, I think that a center bridge in a Pport would be just fine. It worked
great on my West Bends and Power Products Kart engines. I used razor thin
bridges and you had to pin the rings so that an end gap didn't find a port and
snag, but they ran great.
With a 3/8" bridge in the center, I would take the sides out to 1/2" . A
short port top to bottom and real wide. The arched upper (closing) would still be
required. Just a very tiny chamfer around all openings just a degree off of
coincident with the local surface, and a polish job for no problems for the
apex seals.
When do we start?
Lynn E. Hanover
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.