George Lendich wrote:

Paul,
As promised an update on the progress of the bellhousing.

As I intend to use this mock-up to make a mould (Plug) I've laid it on a piece of plastic covered board and sealed around the bottom edge with a concave bead
of water based filler and will allow it to dry thoroughly.

I've already waxed the mock-up but will give it another coat before I apply two coats of PVA Mould release.

I've purchased the glass and Core-Mat (5mm) and will lay it up as soon as all is ready.

George (down under)

Looks good George. I'll have a look around LA and see if we can get it cast 
in magnesium as 5 mm .196 inches wall will be a bit heavy in aluminum. 

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.