Subject: 2nd gen intake manifold
From: ACRE
Date: 5/3/2004, 8:33 AM



How does the weight of this 2nd gen intake manifold compare to the current
(Lamar) flange and castings if used in a NA mode?  Would it be
easier/cheaper/ etc. to take a 2nd-gen manifold and cut off part of the the
intake end, and either flip it over and weld it or the bell-mouths back on?

Scott Gettings


That is a good idea. Weld a set of our bell mouths on. I'll have to
check the diameter as I think I have one in the hangar. You might need
to smooth the transition with a die grinder as I think our bell mouths 
might be slightly larger in inside diameter than the Mazda runners.

The weight is about the same or maybe a little bit more. Sand castings are not
the best when it comes to weight. My intake manifold uses pipe  
bends which save a bit of weight.

The overall height of the engine will be three to five inches higher 
due to the increased clearance between the stock runners and the top of
the engine. Not something that won't fit in a pusher however.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.