Alex Madsen wrote:

Ok. Here is the carbon fiber p-port intake manifold concept. I found a perfect throttle body for it. Unfortunately the TBs are a little on the expensive side
at ~$200 each. Don't worry about fuel rail placement, I have it figured out.  This will be it for manifold development for the next few weeks. I have finals
then I am moving to CO and starting my internship. The length of the runners is not set. At the moment they are about 17 in.

Alex Madsen

You still need a plenum and an air filter Alex. It would be better if you
made the runners round so one could adjust the length according to the
gear box ratio he was using. What throttle bodies are you proposing?
Most throttle bodies are over kill and consequently too expensive as we don't 
need throttle position sensors or mass air flow sensors.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.