Subject: P Ports CF Manifold
From: ACRE
Date: 5/22/2004, 11:31 AM


Alex,  the throttle bodies are located right at the ports.  They
are 2"
O.D. They are parallel to the horizontal thrust line so the runners
need turn 90º to go up the side of the engine and another 90º to go
over the top.  There are four injectors, two for each runner.  These
are required by Tracy's controller.  All four injectors share the
same
fuel rail--refer to Paul's rhino drawing of this. The runner length
should be 22 inches for the 6000 rpm and somewhat shorter for 7500
rpm.
  Maybe someone can suggest a compromise length that will work well
enough throughout that rpm range.  I have a 12A housing into which I
can install a dummy throttle body and send to you.    Jerry

Jerry,
I just need to clarify a couple of things.

Why do you need to come out of the housing parallel to the thrust
line when
it seems more obvious to come out at an angle parallel to the
intended port
area. Is there some performance problems here, perhaps something to
do with
the throttle body butterfly?
I hope I'm being clear?

Also 22 inches seem a lot when Paul's recommendations are 17" and
someone
mentioned 13" for the length of the runner - I am somewhat confused
here!
I'm also working on a 12A for a test-bed and what size throttle body
port
size do you recommend and what length runner.
George (down under)


Just make it so you can adjust the length with hose clamps and rubber
hose.

Paul Lamar

I believe Paul's recommendation for runner length for a 6000 rpm engine
is 22 inches.   As the RPM goes  up, the runners get shorter.   I don't
know how critical this is but getting as close as possible  to the
ideal is our goal.   The only reason we  have the insert set in
parallel is to gain runner length.  It does not effect performance.
What does effect performance is port location, size and perhaps  shape.

  Location and size are just another way of saying timing.   If you
increase the size of the port you will effect either the opening or
closing events and probably both.  Same is true if you change its
location.   In our case we have minimized exhaust overlap while
providing a port that is sufficient to deliver all the charge needed
to run at  8000 rpm.  I forget at the moment where our  port reaches
max flow, but it is far below 10,000.  That is where RB's is just
kicking in.

I don't know for the 12A but I do know that there are some very
powerful p ported 12As out there.

 BTW,  for those who want to experiment,  I will be glad to supply the
throttle bodies.  You can bore them to any size you want and place them
anywhere in the housing  you like.  I will be very interested in
reading the reports.      Jerry

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.