Alex, the throttle bodies are located right at the ports. They are 2"
O.D. They are parallel to the horizontal thrust line so the runners
need turn 90º to go up the side of the engine and another 90º to go
over the top. There are four injectors, two for each runner. These
are required by Tracy's controller. All four injectors share the same
fuel rail--refer to Paul's rhino drawing of this. The runner length
should be 22 inches for the 6000 rpm and somewhat shorter for 7500 rpm.
Maybe someone can suggest a compromise length that will work well
enough throughout that rpm range. I have a 12A housing into which I
can install a dummy throttle body and send to you. Jerry
Jerry,
I just need to clarify a couple of things.
Why do you need to come out of the housing parallel to the thrust line when
it seems more obvious to come out at an angle parallel to the intended port
area. Is there some performance problems here, perhaps something to do with
the throttle body butterfly?
I hope I'm being clear?
Also 22 inches seem a lot when Paul's recommendations are 17" and someone
mentioned 13" for the length of the runner - I am somewhat confused here!
I'm also working on a 12A for a test-bed and what size throttle body port
size do you recommend and what length runner.
George (down under)
Just make it so you can adjust the length with hose clamps and rubber hose.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.