Richard wrote:

Here is a picture of the P-Port solution on the one-rotor. I put an AL plug in the unused tension bolt hole and threaded a stud in. I also use the upper
exhaust bolt for the intake flansh. This insert will never come out with the intake in place.
The exhaust is mounted with a 4-bolt flange.

Richard Sohn
N-2071U
unicorn@gdsys.net
www.gdsys.net/WWWmembers/unicorn/

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.