Tom Webber wrote:

Hey Jerry,  would you like two housings?  I have two,  I'll send

only

the one if thats all you need.  Let me know.  I'm boxing up the
housing
to send today or tomorrow.  Tom Webber

At the risk of sounding greedy,  I would like to have two.   Let

me

know and I will send check for your expenses.  Thanks  Jerry

Jerry its for the cause,  Besides these are just anchors.  Once you
get
the process set up for the P Port Rotor housings, let me know and I'll
purchase two new housings and send them your way also.  I'll have
these
in the mail this week.  I'll let you know what the damage is and we
can
settle up later.  Tom Webber

Thanks again, Tom,   I am sure that we will be ready to deliver on p
ported housings with throttle bodies  before Oshkosh.  I am spending
tomorrow trying to find someone who can supply the 180 sweeps for the
intake manifold.  If anyone has any suggestions about where to look,
let me know.  Should be 2" o.d.   Paul,  do you have a drawing shows
the sweep radius?   Is there any  hope that you will be able to provide
  the casting of the injector end?    Time to rock and roll .      Jerry

It will be awhile before I get the NC mill working to make new patterns.
I think you will need to get Ed Klepeis to weld them up in aluminum.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.