Richard wrote:

Here is a picture of the P-Port solution on the one-rotor. I put an AL

plug in the unused tension bolt hole and threaded a stud in. I also use the
upper

exhaust bolt for the intake flansh. This insert will never come out with

the intake in place.

The exhaust is mounted with a 4-bolt flange.

Richard Sohn

Richard,
Where did you place your ports - directly opposite the original port opening
in the cast iron housings?
George (down under)

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.