Subject: P Ports CF Manifold
From: ACRE
Date: 5/26/2004, 8:24 AM


 I don't know for the 12A but I do know that there are some very
 powerful p ported 12As out there.

 BTW, for those who want to experiment, I will be glad to supply the
 throttle bodies.  You can bore them to any size you want and place them
 anywhere in the housing you like.  I will be very interested in
 reading the reports.      Jerry

 Jerry,
 My calculations show with a 20% allowance for turbulence across the
 butterfly and parasite drag through the pipes the diameter is 1.75"
 Having said that the exhaust out let is about 1, 3/8" Max on the 12A and I'm
 hesitant to go beyond that width for the 12A.

 BTW can anyone give me the width of the 13B exhaust port.

 I figure I can make the inlet oblong rather than oval, to make -up the
 difference in area lost.

 This then brings me to another point. From my observations the opening of
  the PP starts somewhere later than the standard port opening ( the
 opening is over the adjacent lower bolt hole).

 This may explain why some manufacturers slope their inlet tube to compensate
 for that  'bolt hole' restriction and to place the timing as close to the
 original opening as possible.

 However there is more than enough area on the top side ( as the top adjacent
 bolt hole is unused - can anyone say why this bolt-hole is not used?)

 Can anyone explain how this affects the timing, or do I have to get a rotor
 and shaft set-up to visualize it.
 George (down under)


 Port timing is very important. Intake port closing point is the most
important for determining where mid range power is going to be.

Buy or construct a very large degree wheel, and mount it on a crankshaft nut
that has been cut through. I use a Mr Gasket wheel. I made a notch in the nut
and threaded a hole in the notch so I can use a set screw to spread the nut
open a bit. I then crushed the saw cut closed a bit to grip the shaft very
tight. I tighten the screw to make the nut loose on the shaft.

The degree wheel is fastened to the nut with two 10-32 screws.

Make up a pointer to fasten to the engine stand. Find true TDC and adjust the
pointer and secure it.

Install rotor, rotor housing and dowels and crank with degree wheel firmly
attached.
That gets you to about the situation in this picture.

Now move the rotor around by turning the crank, and compare the various
timing events as listed on the picture in the next posting or go to the "Rotary
Engines Illustrated" site (http://www.rotaryengineillustrated.com/index.html) and
print them out from there. You can scribe a line at the apex seal location
for each event and from that see where the "hole" for the Pport is going to be
located, for the timing events you choose.

Lynn E. Hanover

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.