Jerry Hey wrote:
Paul here is a drawing comparing the LeMan port with our port The
Leman Port dimensions were determined by scaling off of a drawing
that
was published by Mazda. We opened the drawing in PhotoShop and
since
we knew the height of the housing, the port size could be determined
using tools provided by Photoshop. We did this about two years ago
when
I first started this odyssey. The numbers should be close but not
absolutely accurate. Our port, hence known as the Pfeiffer port,
since Rolf did all the calculations, in addidtion to opening much
later is also nearly .5 inch smaller dia. The I.C. of both ports is
very close. ( I believe the RB p port is 2.25" dia so it is
somewhat
larger than the LeMan port.) Our port is sized to have adequate
flow
up to 8500 rpm. Certainly it is running out of capacity at 10,000
rpm.
You won't be turning 9500 RPM like the Leman engine anyway. You will
be limited
to 7500 due to the prop and the 2.85:1 PSRU. My wild ass guess is it
should develop
at least 210 HP. at 6000 and 260 HP or so at 7500 RPM. We shall see.
Paul Lamar
Might even be better than that. The Pfeiffer port is not round as
depicted in the drawing but is enlarged somewhat. Here is the final
shape. Jerry
Paul Lamar
What happened to the drawing? Jerry
Ops Sorry Jerry. Here it is.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.