Subject: How to save $450 on your engine mount
From: ACRE
Date: 5/27/2004, 10:27 PM

Jerry Hey wrote:

Simple,  you buy a Schertz beam, static load tested and proven,  side
clips welded, mounting holes drilled, ready to bolt up, complete with
Barrys, from me for $200.00.  The rest is just six or eight  tubes that
  you can fit up yourself.  If you are not a good welder, just tack it
together and haul it down to the local TIG guy.  This is what I
recommend.  Since  you are building in place, there will be no problem
with fit up.  If in doubt, call me and I will talk you through the
process.

If you don't care about saving the $450.00,  you can send me $650.00,
a template of  your  attach points at the firewall and  you will get an
engine mount in return.   $650 is about half what an engine mount cost
last year,

Either way you will  save money and weight.   This engine mount is so
clean.  No more clutter of tubes running all over the place, always  in
the way.

The rear strut installation is not included.    There will be a drawing
provided showing a typical installation on a sheet metal firewall which
will need to be stiffened. It is not a big deal.   If  you have a
plywood firewall it will be  even easier.

No more excuses,  time to hang that rotary.    Jerry

Jerry, I have been thinking about that rear strut mounting. If you build
a simple 4130 .040 angle straddle mount bracket and rivet it to the bottom 
of the firewall and the bottom skin of the belly pan where the lower skin 
connects that will be plenty stiff enough. Weld some washers around the 
1/2' holes where the bolt goes through.

Basically is will look just like what Bill Schertz did. I'll do a 3D in
an hour or so.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.