Subject: All aluminum rotary
From: ACRE
Date: 5/28/2004, 9:31 AM


Does anyone have any thoughts on the durability of an all aluminum rotary.
Why hasn't Mazda done it?  Cost or heat efficiency?


Has anyone used the Racing Beat PP housings? I don't feel comfortable
reworking a housing.

PP [rotor housing] for non-turbo
http://www.racingbeat.com/resultset.asp?PartNumber=11021
$837.00

PP [rotor housing] for turbo
http://www.racingbeat.com/resultset.asp?PartNumber=11024
$837.00

What about building up a complete aluminum engine using these parts?
Sure they are expensive, but you are still looking at probably less than
$8K for an engine, low by airplane standards. They have a part for the
20B as well.

Aluminum Intermediate housing
http://www.racingbeat.com/resultset.asp?PartNumber=11061

$1,550.00

Aluminum Rear Side housing
http://www.racingbeat.com/resultset.asp?PartNumber=11071
$1,200.00

Aluminum Front Side housing
http://www.racingbeat.com/resultset.asp?PartNumber=11051
$1,200.00

Aluminum Rear Side housing 20B
http://www.racingbeat.com/resultset.asp?PartNumber=11072
$1,200.00

--
Perry Mick
http://www.ductedfan.com

Douglas Fir wrote:

Does anyone have any thoughts on the durability of an all aluminum rotary.
Why hasn't Mazda done it?  Cost or heat efficiency?


Cost probably. The competition is stiffer now and they need an all aluminum
3 rotor in the RX8. Durability should be about the same as the rotor housing
with steel lined aluminum end housings.
Paul Lamar

I missed the "final answer" on the Racing Beat PP housings. I don't have any
machinist's tools and certainly don't feel comfortable with making this
modification myself. Despite the fact that making the modification ought to be
fairly moderate in cost there are some additional benefits  (weight savings)
to the aluminum housing (does anybody have actual numbers on this?). I seem to
recall some comment that this porting might not be optimal, but would
appreciate some additional feedbacck.

I probably wouldn't try to build an entire engine this way but it might make
it more acceptable to buy a cheap $500 engine that might have wear on the
housings or other issues that would be moot if the problem was on a part to be
completely replaced.

Regards,
Chad

I don't think anybody knows how long the Racing Beat coated aluminum end housings
will last. I was referring to the Mazda method of lining the rotor housings with steel.

My guess is about 50 pounds on the two rotor and maybe 70 pounds on the three rotor.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.