The rear strut installation is not included. There will be a
drawing
provided showing a typical installation on a sheet metal firewall
which
will need to be stiffened. It is not a big deal. If you have a
plywood firewall it will be even easier.
No more excuses, time to hang that rotary. Jerry
Jerry, I have been thinking about that rear strut mounting. If you
build
a simple 4130 .040 angle straddle mount bracket and rivet it to the
bottom
of the firewall and the bottom skin of the belly pan where the lower
skin
connects that will be plenty stiff enough. Weld some washers around
the
1/2' holes where the bolt goes through.
Basically is will look just like what Bill Schertz did. I'll do a 3D
in
an hour or so.
Paul Lamar
OK Jerry here it is for a sheet metal firewall. Something simple. .035
or .040 4130.
Make it five or six inches high and three or four inches along the
bottom.
Four or five inches wide. Rivet it to the sheet metal with a dozen
rivets.
This is a right angle version but some fire walls are not at an exact
right
angle with the belly pan so change the angle to fit. The RV4 is such
and airplane.
Paul Lamar
We must be on the right path since everything is getting simpler. I
will include this fitting with the engine mount, no additional charge.
Thanks, Jerry
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.