Subject: New Topic- Air Cooling a Rotary
From: ACRE
Date: 5/28/2004, 11:39 AM


"Lemings, Bob" wrote:

Paul,

Has any consideration ever been given to air-cooling a Rotary?  I realize this is a fire-breathing heat generator, but one liquid on board is better than two.  What if cooling fins were added to the rotor and side housings and oil flow added to the coolant passages instead of coolant-- increase the size of the oil cooler, oil flow, and the quantity of oil available to recirculate.  Maybe someone out there is proficient in Thermodynamics that could do some calculations?  What are the heat transfer properties of engine oil (Mobil 1, of course) compared to Ethylene Glycol and water.  Ethylene Glycol by itself is very poor, I know.

Bob Lemings

Its been done but the big problem is cooling between the rotors.
No problem on a one rotor engine. Come to think of it that might
be an easier way to make an all aluminum one rotor. I should apply
for a patent :) Also while we are on the the subject it is easier
to make an aluminum front housing if you use an external oil pump.
Are you listening Richard? If you mill some parts of the ribs out of the
rotor housing you could feed coolant into and out of just the rotor
housing and cool the end housings with just air. No casting would
be required for these air cooled end housings as it can all be done
with a manual mill if necessary.

Paul Lamar

"Lemings, Bob" wrote:

Hey, we could go places with an air cooled one-rotor--  Think about a twin 
engine Mustang II, or a push/pull combo, or even your Cruiser with 
an engine hangin' on each side--

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.