Subject: New Topic- Air Cooling a Rotary
From: ACRE
Date: 5/28/2004, 8:07 PM



"Lemings, Bob" wrote:

Paul,

Has any consideration ever been given to air-cooling a
Rotary?  I realize this is a fire-breathing heat generator,
but one liquid on board is better than two.  What if cooling
fins were added to the rotor and side housings and oil flow
added to the coolant passages instead of coolant-- increase
the size of the oil cooler, oil flow, and the quantity of oil
available to recirculate.  Maybe someone out there is
proficient in Thermodynamics that could do some calculations?
 What are the heat transfer properties of engine oil (Mobil
1, of course) compared to Ethylene Glycol and water.
Ethylene Glycol by itself is very poor, I know.

Bob Lemings

Its been done but the big problem is cooling between the rotors.
No problem on a one rotor engine. Come to think of it that might
be an easier way to make an all aluminum one rotor. I should apply
for a patent :) Also while we are on the the subject it is easier
to make an aluminum front housing if you use an external oil pump.
Are you listening Richard? If you mill some parts of the ribs
out of the
rotor housing you could feed coolant into and out of just the rotor
housing and cool the end housings with just air. No casting would
be required for these air cooled end housings as it can all be done
with a manual mill if necessary.

Paul Lamar

How about creating an air-cooled two-rotor by putting two of the
proposed
air-cooled one-rotor's in series?  You could make an intermediate
housing,
the core of which is a mesh of fins for heat transfer.

Grant Schemmel


Hard to get enough air and fin area to cool between the rotors. Not enough
room.

This one rotor version on the other hand is easy to do. Use a peripheral
port and an external oil pump. The rotor housing is still liquid cooled
with modifications to allow the water to flow from chamber to chamber.
New water inlets and outlets are drilled and tapped into the rotor
housing. Cold water into the spark plug area first. The end housings
have simple steel wear surfaces held in place by the rotor housing
and the steel front and rear main bearing holders.

Paul Lamar

Paul Carey wrote:

Hi Paul
I have been thinking a lot about all aluminium rotoraries lately -
particularly in relation to drag racing (ie - run time of no more than 2 - 5
minutes).
My racing advisor has the big huge billet V8 blown alcohol engines - with no
cooling at all, because of the alcohol and short run time. Why can't I use
solid billet end and middle housings (with external oil pump as you say) and
just fill the housing water jackets with special grout the drag racers used
to use before billet blocks came onto the market. Would the heat really be a
problem for me. I can already think of the benefits in rigidity and possible
CNC changes to the end housings for my blower mounting etc. What do you
think Paul - can it work?
PC

Paul Carey LAME, MC
Aero Management - aviation consultants.
www.aeromanagement.com.au
(08) 9371 5205  0418 959 892

Yes I think that would work. You could still cool the oil.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.