Jerry Hey wrote:

Paul,  I am going to build a Kiss Cruiser Schertz Beam engine mount.
Could you determine in your CAD program if the 32.5 inch (overall)

beam

will clear the cowl?  BTW it does clear the Tailwind cowl by 1.5
inches.  Most cowls are more spacious than the TW.   Do you have a
drawing on hand of the Long EZE that you could check for same?   If it
fits the Kiss and the Long EZE, then it will fit anything.     Thanks,
Jerry

Jerry Hey
j-winddesigns@thegrid.net

I don't have a good 3D model of the Cruiser cowl. Best thing I could do

is mock

it up with a piece of wood and see if my cowl fits over it. My guess is

it would fit.

One point. The Schertz beam lowers the position of the rubber bushings

relative

to the engine compared to the motor plate method so it might get them

down in

the area of the cowl that starts to curve under the engine. I assume

that Bill

Schertz's cowl fits over his Schertz beam. In that case it should fit.

Bill

is that true?

BTW there are two cruiser cowls both Bill Schertz and I have the early

short ones

as I recall. I think there is a later longer one. Charlie what is the

distance

from firewall to prop flange on your Cruiser cowl? Also Charlie check

these

Cruiser firewall mounting points dimensions carefully. Since Charlie is

not

that far from you perhaps he can bring his cowl down.

I don't have much on the Long EZE. I'll check.

Paul Lamar

I have never attached the cowl to the fuselage so I can't give you a

measurement on the plane without a bunch of work (cut out area for front
gear).  The joggle on the front where the cowl mates is at the firewall.  So
what I did was lay the cowl upsidedown on the shop floor and measure it from
end to end.  It measures exactly 36 inches.  This should be extremely close
to the distance from firewall to prop flange at the beltline.

I did cross check the mount point dimensions versus the drawing I gave

to Jerry (a cleaned up version of what's on your web page, Paul).  To the
extent I can determine, they are exact.  However, the locations are only
marked with 1/8 inch holes drilled through the firewall.  These do not have
to be exact as the area that has been reinforced on the interior side to
hold the mounts is substantial.  My guess is that the location could drift
by 1/4 inch and still be OK.

Bill, what do you think?

Charlie Smith
KIS Cruiser 4021

I think you can have 1/4" slop in the location of the mounts with no
problem.
Bill Schertz
KIS Cruiser # 4045

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.