Subject: How to measure your cowl for motor mount clearance
From: ACRE
Date: 5/31/2004, 1:05 AM


Place the cowl in a corner of a room.
Draw a horizontal line on the wall up from the floor the same
distance from the firewall as the Schertz beam will be using
a carpenters level.

Mark off the line every 4 or 5 inches.
Use one of those construction lasers that project
a beam perpendicular to the wall. Use a magic marker
to mark the laser spots on the cowl.
Measure the distances from the wall to the magic marker spots
on the cowl and you now have the coordinates of the cowl curve.
Should only take a few minutes.

Send me the numbers and I can do a 3D of the cowl if I have the
shape of the firewall and the size of the spinner.

Paul Lamar


Paul,

I'm guessing this instruction was for me since I made the mount request to Jerry.  I've already started working on this by removing the nose gear.  I retrieved the lower cowl from its storage area and attempted to fit it to the fuselage.  I noticed a scribe line on the cowl so the 36" figure I gave includes this and probably shouldn't since you typically have to trim scribe lines.  This brings the cowl length down to about 35".  I do have a laser on a tripod but it doesn't project a line only a spot.  I was planning to mount the cowl on the plane, level the plane and then use a straight edge across the top to bridge from side to side on the top of the cowl.  Starting at the firewall, I could measure from the bottom of the straight edge (which is the top of the cowl) and give you a "depth" every few inches from left to right.  Then move the straight edge forward 3 or 4 inches and repeat until I reach the very front of the cowl.  This should map the interior of the cowl nicely.

As for measuring up from the firewall to the same distance as the beam, I don't know how far that is.  Somebody will have to let me know, if it is important.  Right now, mapping the cowl for 3D seems the way to go.

Perhaps I can do this tomorrow.  We'll see.  There has been a great deal of foul weather locally today and even worse is predicted tonight.  A small town about 10 miles away was devastated by a tornado this afternoon (official estimates indicate 50% of the town is destroyed).  They may need volunteer help and if so, this will wait.

Charlie Smith
KIS Cruiser 4021

The distance is 16 inches back from the cowl prop flange opening or 21 inches up
from the floor. Your cowl sounds a bit shorter than Bill's and mine. Mine is at
the hanger. Bill what is the lenght of your cowl?

Paul Lamar

You don't really need a laser if you have a tape measure like this with
a squared off back side. It will measure perpendicular distances.

I also need the cowl curve from top to bottom to be sure the rubber motor
mount holder will clear the cowl. Best to set it up like this 3D in order
to get that curve.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.