Jerry Hey wrote:

Paul,  I have been thinking about passing  aluminum  intake runners
through a block of aluminum which  could then be drilled for the
injectors.  What do you think?  I hope you don't ask for a drawing
because my CAD has slipped to completely useless.        Jerry

Yes I think than will work. However Ed could just weld on two one inch
aluminum bar stocks at an angle side by side. Clamp it in the
drill press with an angle plate and drill the holes for the injectors.
Take the little plastic tip off the end of the injectors.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.