Subject: failed unducted fan experiment
From: ACRE
Date: 5/31/2004, 8:48 AM


With the 38in dia at 5500 the tip speed is a tad above 900 fps, a bit high
for a typical thick wood prop but modest for metal or composite sections.
A search on net suggests that at least at one time the soob was running
about
50 inch dia and 60 in pitch - looking for 4000 where the Soob shoud be just
a tad over 100hp. I was suprised to hear that your exit area is greater than
the
fan area. This means that you are diffusing the flow velocity down before
exit. This cannot be good. Treating your whole plane as a controll volume,
thrust is the total air weght flow times the difference between entrance
velocity and exit velocity, so diffusing that exit flow is thrust loss.
Only sonic throat flow (ie rockets and turbojets) benifits from a
diverging exit. Vance


Basically the reason it works Vance is it increases mass flow. It is
more efficient to have high mass flow and low delta-v, than to have high
delta-v and low mass flow. The fan is truly working in a 200 mph
environment, while the aircraft is in a 160 mph environment.

Perry

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.