Jerry Hey wrote:

Paul,  would it be possible to exit the exhaust pipe(s)

directly below

the exhaust ports or straight out from the exhaust ports  and

run it

outside the cowl? Perhaps the cowl could be tunneled  so the

exhaust

pipe would be more or less  flush  and out of the air stream

Jerry

It would be VERY noisy :) I think you will need some sort of

muffler.

Perhaps an internal tangential and a an external one. Tracy new

Flow

Master muffler is holding up well and it does not add that much

drag

and it is relatively cheap. Much cheaper than a spin tech.
Here are a couple of pictures I took a few weeks ago while
I was in Florida. It is not round. It is wide and flat. Tracy's
thinks the reason it is living so well is the fact that joints
are minimized being made from steel pressings.

I am sure he bought it at Napa as that is where he gets all his
parts. Only auto parts store in all of Bell :)

Laura can you find the receipt for Tracy's Flow Master muffler
and get the part number for us? Thanks. I don't want to bug
Tracy as I am sure he is making and shipping parts.

Paul Lamar

géraldine berger-yvon cournoyer wrote:

Allo Paul. The pictures did not arrive here in Québec, Are we too
far from  southern California?
Yvon

Probably your ISP (videotron.ca) is too far from the real world :) 
Try changing your Internet Service Provider.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.