Subject: Oil pump cavitation, Oil flow
From: ACRE
Date: 6/2/2004, 11:33 AM


I have been thinking about this for the last couple of weeks and was
getting
ready to duplicate your experiment with a front cover and 2d gen oil
pump.
You mentioned oil foam in some of your early posts on this subject. At
what
point in the system was that observed? That concerned me because some of
our
oil cooling problems could be explained by the existence of oil foam in
the
oil cooler. First thing I am going to do is find transparent line
that will live over 100 psi.

Paul Lamar

Paul,  we don't have any transparent oil line on our oil pump test rig.
However, we have a transparent oil pan and we see how the pump turns
clear oil into milky oil quite rapidly at high flow settings.  But it
would be great if you could do a few experiments for us, we just don't
have the time to check everything.

Francois

Well I think what is happening in your test rig is the rapid expansion
of the oil pipe immediately after the pressure restrictor valve is causing 
the foaming problem. the red arrow points to the spot where I think
this is happening. A more gradual reduction in pipe diameter may
not show the same results.

Perhaps it would be better when designing the test rig 
to have the rest of the engine on there so one could get a more realistic
view of the oil exiting the engine. Now having said that it is well
known that the oil circulating around inside the rotors on a running
engine generates a lot of foam. this is addressed by having a plate
between pan and engine with small holes to act as an air oil separator.

I think what I should do is motor the whole engine with my 5 HP electric
motor with the spark plugs removed. I'll see how many RPM's I can get
out of it doing  it that way. At the same time I will be able to
measure the motoring HP for academic interest using Vance's water pump
test rig.

Another approach is the have the engine assembled without the rotors
and e-shaft to simulate just the oil passages. Perhaps the oil feeds to
the main bearings could be restricted.

I'll use transparent hose between the engine 
and the oil cooler. 

I am not sure I will have time to do this any time soon.
But if anybody else is willing to do this we would all appreciate nailing
down this problem. I do agree that foam in the oil cooler is not good.

There is no question that a larger and or better pump will pump more
oil and generate more pressure.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.