Subject: failed unducted fan experiment
From: ACRE
Date: 6/2/2004, 11:15 AM


     A good part of the problem is the duct weight increase. A hollow carbon fiber
     duct would mitigate some of that. Not available when Raspet was alive.

     Here again is the data from K&M Aerodynamics of Propulsion with some of the
     surrounding text. Note the drag contribution of the duct to the overall
     performance. The data is plotted relative to the advance ratio on the x axis.
     Very typical for propellors. A turbo fan on the other hand would have
     advance ratios of well over one at low speeds and that is kind of what K&M
     are referring to when they speak of disk loading. Also note that opening up the
     exit area (the right side chart) increased the efficiency plotted on the y axis.
     That is what Perry verified.

     The DRAG of the duct DROPPED the OVERALL efficiency almost 30% at advance
     ratios over .4 (high speed).

     Note also the inverted airfoil shape of the duct. I am sure Raspet had this
     book since it was published in 1953.

     IMHO with a much larger radius on an inflated lip such as I am suggesting
     low speed thrust would be greatly increased and the duct could then be made
     thinner or smaller in diameter with less high speed drag. A smaller diameter
     duct with a higher advance ratio, higher disc loading fan could allow the
     rotary engine to rev higher and generate more HP and still have the same
     low speed thrust advantages. In other words it would become more like
     a turbo fan but have much better low speed thrust.

     I also think with a pito tube placed behind the fan the consequent air
     pressure might inflate the lip. Normal inflow into the duct would also
     help inflate the lip. A two way valve could shut off the pito
     tube pressure and vent the lip volume to the atmosphere collapsing the
     lip. Better yet to a source of low pressure forcing the lip to collapse.
     No compressor required. Patent applied for :)

     BTW if you make the duct too short there will be reverse re circulating flow on the
     out side skin of the duct drastically reducing the low speed thrust.

     Paul Lamar

Using a variable exit diameter would improve thrust with low drag increases.
A limited variable exhaust nozzle would seem to be a great aid to tuning.
Bill Jepson

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.