Subject: Oil pump cavitation, Oil flow
From: ACRE
Date: 6/3/2004, 9:14 AM

Al Gietzen wrote:

Another data point:
The stock 20B pickup tube is rather long with a number of bends, which
seemed to me could be a limiting factor in oil flow.  I have a custom
deeper
pan (about 6"), and I made a custom pickup tube going straight down
from the
pump inlet - as I recall the tube is about 5-1/4" long.  I used a 3/4"
SS
tube with an i.d. that matches the pump inlet quite closely (a tad
larger).
I intended to flare the inlet end of the tube, but decided to forego
that in
order to install the stock inlet screen.

For the dyno runs we ran Castrol 20-50.  The oil pressure regulator
valve in
the engine is 100psi.  The oil goes first through the dyno cooler
loop, and
I don't know what the pressure drop there is.  The flow rate as a
function
of engine RPM is shown on the attached chart. I don't know what pump
speed
is.

The curve is quite linear up to about 5000, and then begins to bend
over a
bit.  Flow at 6000 it is 14.2 gpm.  At 5450 engine rpm the flow is
13.6 gpm
- lower than Francois reports on their engine, but I don't know if the
gearing ratio is the same.

FWIW,
Al

Thanks Al for this data.

What oil pump model do you have on that 20B?

Assuming you have the '93 model with the side passageway, we get
approximately 45% higher flows on the test rig, with a straight pickup
tube and NO INLET SCREEN.  If we change the pickup tube to one with the
stock inlet screen, then we get PRECISELY the same flow curve as you do.

We would have thought that this inlet screen could make that much
difference.  We'll have to test different screen geometries as we cannot
afford to lose that much flow.

Francois Badoux

I'm not certain of the pump model (Dave Atkins rebuilt the engine) but I
presume it is the stock 20B pump.  It seems unlikely to me that the screen
could make that much difference.  I estimated the total area of the screen
to be about 30 sq. cm.; and that the open area was about half of that.
However; if the domed screen is against the bottom of the pan, or the end of
the tube is near the screen (or both), the effective area would be much
less.

Al

Is it a real 20B Al or  has it been made with 13B parts?

Paul Lamar

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.