Subject: Paul, the latest on the RX-8
From: ACRE
Date: 6/3/2004, 7:30 AM


Has Conser wrote:


Paul, they have a new ECU Flash for your RX-8, the "M" flash, this
bulletin has the details on this and also the latest restart
procedures.

Hans


Ever since we flooded the RX8 the first time we have been very careful
about moving it for short distances or stalling it before it is warm.
It has not flooded on us again.

Cranking it over with the plugs out is not the best way to get
all the fuel out of the rotor housings. Much of the raw fuel
merely bypasses the spark plug hole. A better way is use a
plastic squeeze bottle and a small hose inserted into the
lower spark plug hole with the front rotor 180 degrees past top
dead center. Same for the rear rotor. When that is finished you
could squirt a little oil in there to restore the compression.

The ultimate solution is a small 12 Volt or 110 volt ECU controlled
block heater installed in the lower part of the rotor housings to vaporize the
raw fuel. They are going to need something like that up in
the northern countries like Canada, Alaska and Russia anyway.

Paul Lamar

Paul...and Hans and others...

I try to be careful, too, but I flooded mine again, after washing the car then having to quickly pull it in the garage as it started to rain!

I've made an appointment for the version M flash update Tuesday.  Meanwhile, I found the service bulletin for this upgrade in pdf format online here:

http://www.finishlineperformance.com/rx8/docs/01-011-04-1273d.pdf

It includes instructions for "dechoking" in the case of flooding (includes depressing the accelerator fully down, as this apparently shuts off the
injectors).

They also suggest first unplugging the air injection pump to prevent "rapid light off of unburned fuel".  In case the "de-choking"  doesn't work, they also
include procedures to empty the chambers of raw fuel remove plugs, and crank) and a last step if necessary, to restore compression by sucking oil into it
through the front vacuum plug on the lower intake manifold. Has sketches showing where the plugs and connectors are located.

I printed it out and saved it, but if my past experiences are typical, I'll never need it now!

Harley Dixon

I sent the pdf file Harley. Did you get it?

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.