Subject: Paul, the latest on the RX-8
From: ACRE
Date: 6/3/2004, 12:24 AM

Has Conser wrote:

Paul, they have a new ECU Flash for your RX-8, the "M" flash, this
bulletin has the details on this and also the latest restart
procedures.

Hans

Ever since we flooded the RX8 the first time we have been very careful
about moving it for short distances or stalling it before it is warm.
It has not flooded on us again.

Cranking it over with the plugs out is not the best way to get
all the fuel out of the rotor housings. Much of the raw fuel
merely bypasses the spark plug hole. A better way is use a 
plastic squeeze bottle and a small hose inserted into the
lower spark plug hole with the front rotor 180 degrees past top
dead center. Same for the rear rotor. When that is finished you
could squirt a little oil in there to restore the compression.

The ultimate solution is a small 12 Volt or 110 volt ECU controlled
block heater installed in the lower part of the rotor housings to vaporize the 
raw fuel. They are going to need something like that up in
the northern countries like Canada, Alaska and Russia anyway.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.