Subject: Oil Pan-plenum-rad -louver holder
From: ACRE
Date: 6/5/2004, 4:03 PM


Jerry Hey wrote:

Consider making the bottom of the oil pan from a sheet of aluminum
folded to make up the sides of the plenum.  It could be extended  down
to hold (first) the radiator (tabs with nut plates welded to rad)  and
(second) the louvers.   This would completely eliminate the VERY LARGE
problem of how to hang the rad and louvers.      Jerry


That is a great idea Jerry. I was just about to say the new Kis layout
box Schertz could use the stock oil pan:) This might improve the oil cooling
a bit as well.

Paul Lamar


Paul,

Forgive the novice question but it seems you describe a layout much like in a car.  Oil cooler in front of the radiator, correct?  Are the louvers you describe there to straighten the airflow into the radiator?  Also, has anybody investigated the heat exchangers used by race cars to cool the oil?  Would they handle the pressure I wonder?

Charlie Smith
KIS Cruiser 4021

The drawback to that scheme is the hot air from the oil cooler is now trying
to cool the water rad.

It is along side the rad Charlie. Both cores can be 19 inches long.
those louvers are the exit air louvers on the bottom of the cowl.
Anything within ten inches of the back side of the rad will reduce
the air flow. iI is necessary to dump the used rad air directly
to the out side of the cowl. 

the Kis has that fat bulge on the bottom of the cowl so that might work alone.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.