Jerry Hey wrote:
Consider making the bottom of the oil pan from a sheet of aluminum
folded to make up the sides of the plenum. It could be extended down
to hold (first) the radiator (tabs with nut plates welded to rad) and
(second) the louvers. This would completely eliminate the VERY LARGE
problem of how to hang the rad and louvers. Jerry
That is a great idea Jerry. I was just about to say the new Kis layout
box Schertz could use the stock oil pan:) This might improve the oil cooling
a bit as well.
Paul Lamar
Barry Gardner asks:
Can I ask a couple dumb questions?
1) When we create odd-shaped oil pans, I'm assuming that it is important to create a custom oil pickup that hits the lowest part of
the pan. Certainly one would want to have access to as much oil as possible in case the engine burns or leaks some. True? Is there a limit on how deep or
far that pickup can go?
2) Is a dry sump alternative a good one for the 13B? No one seems to propose that and I wondered why not. Granted, it would cost a few bucks more but
wouldn't it relieve the space crunch under the engine and increase engine layout flexibility?
Barry Gardner
Wheaton, IL
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.