That should work just fine Perry but a bit heavy at 4 pounds less
the holes for a narrow Schertz beam.
On the other hand it is easy to make too as you can order the
aluminum plate sawed to size from the metals dealer. Then all you
must do is drill the holes.
I suggest moving the large rubber bushing holes forward a bit since
you don't have the weight of a PSRU to support. That will save a bit
of weight and cost on the rear beam.
Paul Lamar
The reason I put them to the rear like that, is that if they are in line
with the rear housing, the oil port interferes on the left side and the
rubber starts to get in the way of the exhaust system on the right.
With them where I put them, I can also move them closer to the eshaft, keep
the cowl narrower. The one on the left may interfere with my current starter
location, but that can be modified.
Perry
Oh OK.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.