While you're at it, you might consider making the aluminum oil pan with cooling fins similar to mine. See attached pictures. Paul Conner
Nice work Paul. Did that guy in Denver build it for you?
Paul Lamar
Hi, Paul....I believe it was made in Denver....Perry Mick arranged
everything, including size/specs and then he drilled the mounting holes in
it, and shipped it to me, for a very reasonable price. Thanks, Perry. Paul
Conner
Hope it helps. Do you have one too Perry?
Paul Lamar
Yes, I had one built for me, Paul got the second one. I didn't notice
any difference. I could never find a suitable extrusion that was readily
available. So the fins are welded on pieces of 1/16 x 1 alum. angle.
It's just too much work for the welder. So I decided I wouldn't pursue
it any further unless an extrusion source was located.
I've been working on the 3D of my new engine mount for the Long-EZ. The
Schertz beam is 1/2 x 4.75 x 15.5 aluminum, that picks up every hole on
the rear iron housing. It also pushes the rubber mounts rearward and
inward. I want to incorporate the 1/2 inch beam and the 1/2" front piece
into the oil pan, such that the whole assembly bolts to the engine just
like any other oil pan. I remember that 1/2" aluminum is very difficult
to weld, so the front and rear 1/2" pieces may have to be bolted to the
pan from inside, sealed with sealant. The extra pieces shown at the
front are the tabs on the 13B front cover and L-brackets between the
tabs and the front 1/2" piece for more support. Also, I removed the oil
pan fins, they will only be included if an extrusion becomes available.
Perry
That should work just fine Perry but a bit heavy at 4 pounds less the holes
for a narrow Schertz beam.
On the other hand it is easy to make too as you can order the aluminum plate
sawed to size from the metals dealer. Then all you must do is drill the holes.
I suggest moving the large rubber bushing holes forward a bit since you don't
have the weight of a PSRU to support. That will save a bit of weight
and cost on the rear beam.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.