Jerry Hey wrote:
On Tuesday, June 8, 2004, at 05:14 PM, ACRE wrote:
Jerry Hey wrote:
On Tuesday, June 8, 2004, at 12:42 PM, ACRE wrote:
Paul, my drawing of the MMP indicates the vertical centers of
the
two bolt holes are .330" apart. Your drawing shows .080.
Jerry
Mine shows .8. I was very careful about measuring this.
That got my attention! I checked several different drawings and got
.33 on all of them. Evidentially, I transfered this measurement from
drawing to drawing. Danny's NC program was right on, however. We
have bolted up a number of these without problem. So I measured my
mmp which is still on the engine. No happiness for either of us. The
vertical distance is .68 inch. I checked it more than once. Jerry
Paul<box-schertz3-2D.jpg>
That will surely make it easier. I may have an older end housing here.
I'll check some other end housings up at the hangar.
If it is really .33 center to center vertical off set we might be able
to go back to the one piece beam. I'll lay it out in a few hours
and get back to you.
Paul
Not .33 but maybe .68. Things are lookin good with the engine mount.
When I get back, I will make one for my airplane as a test. I will
also make one for Ed so that he does not have to guess when he is
building the exhaust. I'm heading down to Kentucky tomorrow. Will
meet with Ed on Thursday. We want to talk about the intake manifold and
various exhaust options. He is still pretty vague about the rotary
installation. Then on Fri and Sat I will be at the SAA in Urbana
Ill. Lots of Tailwind will show up. Jerry
OK
Paul