Jerry Hey wrote:
A month ago I posted a jpeg of the prototype p port throttle body. The
main criticism was that the butterfly was the same size as the port:
i.e. 1.5 inch. Since the butterfly somewhat blocks the passage, it had
to be made larger to allow for enough flow. It was recommended that
the butterfly be enlarged to 1.625 in. This we have done. We also
added a throttle stop so that idle can be set. And we reengineered the
attachment of the butterfly control arm so that it cannot accidentally
come off the shaft. The shaft turns in bearings and is silky smooth.
In the first photo the little tube is a pressure tap required by the
EC2. The long screw is the throttle stop. At its base, hardly visible
is a nut that locks it in position. The screw sticking out of the
control arm contacts the bolt to set the idle. The second photo
shows the butterfly axle and the bearing which is retained by the
little screws. The third photo shows the butterfly from the intake
side. You may be able to see that the bore is tapering down to the
butterfly (1.625 in) It starts out at 1.75 i.d. to match the bore of
the manifold tube. The last photo is from the perspective of the
rotor. In this view the bore is tapering down from the butterfly to
the 1.5 exit. Note the thick (.375 in) walls. This is material for
the die grinder, if you want to experiment. . Our port is sized to
run great up to 8000 rpm so you may not want to touch it at all.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.