Jerry Hey wrote:
A month ago I posted a jpeg of the prototype p port throttle
body. The
main criticism was that the butterfly was the same size as the
port:
i.e. 1.5 inch. Since the butterfly somewhat blocks the passage,
it had
to be made larger to allow for enough flow. It was recommended
that
the butterfly be enlarged to 1.625 in. This we have done. We
also
added a throttle stop so that idle can be set. And we
reengineered the
attachment of the butterfly control arm so that it cannot
accidentally
come off the shaft. The shaft turns in bearings and is silky
smooth.
In the first photo the little tube is a pressure tap required
by the
EC2. The long screw is the throttle stop. At its base, hardly
visible
is a nut that locks it in position. The screw sticking out of
the
control arm contacts the bolt to set the idle. The second
photo
shows the butterfly axle and the bearing which is retained by
the
little screws. The third photo shows the butterfly from the
intake
side. You may be able to see that the bore is tapering down to
the
butterfly (1.625 in) It starts out at 1.75 i.d. to match the
bore of
the manifold tube. The last photo is from the perspective of
the
rotor. In this view the bore is tapering down from the butterfly
to
the 1.5 exit. Note the thick (.375 in) walls. This is material
for
the die grinder, if you want to experiment. . Our port is sized
to
run great up to 8000 rpm so you may not want to touch it at
all.
Looks great Jerry, did you receive the rotor housings / boat anchors
yet. Hope they didn't go around the earth in the wrong direction, if so
that could take a while. I know I told the UPS agent send them to the
east, he was kinda hard of hearing. Let me know when your confident on
boring and installing these throttle bodies in some new housings and
I'll get some headed your way. Thanks for all the great work. T.W.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.