Subject: P Port throttle bodies
From: ACRE
Date: 6/9/2004, 8:00 AM


<< Jerry Hey wrote:
 >
 > A month ago I posted a jpeg of the prototype p port throttle body.  The
 > main criticism was that the butterfly was the same size as the port: >>

Very nice piece. One seldom used trick to assure retention is to have the
clamping bolt hole intersect 5% of the shaft bore, so that the shaft must have a
slight groove machined in it to complete the clamping bolt hole. So long as
the clamp bolt is still present, even if stripped or broken, the throttle lever
cannot be removed, or turn relative to the shaft. Provision for safety wire is
required.

Lynn E. Hanover


 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.