Subject: P Port throttle bodies
From: ACRE
Date: 6/11/2004, 10:01 PM


Jerry,
Fine looking job on the throttle body/s. I would like to make a
suggestion. For aircraft use we would like to have a very tight and reliable
fit. My
suggestion is to make the the hole bored into the housing a .001 inch
press fit. The insertion can be made using  liquid nitrogen. The fit will
seal itself
but you can still put some epoxy on the housing prior to inserting the
body. The housing and the body stabilize all will be well. Just my $.02.
Bill Jepson


Bill,

Are you alluding to the possibility of a less than water tight fit?
It has been suggested (to me) that it may be a possibility.

If so! my suggestion would be to step the Throttle Body OD to allow for 2
O-rings and use two studs to hold the TB in and to keep pressure on the
O-rings. Perhaps one could use the current stud  and another at the top.

>From pictures of Richard Sohn's project it would appear  he is using studs
to retain the TB.

I think I will do it that way if I can.
George (down under)

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.