I was working on the plumbing yesterday and had a little trouble
getting the Earl's beading tool into the tubing. Turns out if
you get too close to the bend the tube is distorted and it becomes
nearly impossible to get the beading tool into the tubing.
I had to take the tool apart and turn it down in the lathe about .010 or .020.
Once I did that it worked fine. The secret to using it is clamp the tool in
a vice and turn the tubing. A bit of Mobil 1 on the tool does wonders.
The Breeze Constant Torque hose clamps come in two varieties.
A large one and a slightly smaller one. The slightly smaller one
works fine on 1-1/2 tubing but you need the larger one for casting
barbs like the water pump.
Also shown is a proper silicone rubber hose ($1 an inch) connection using
the slightly smaller Breeze Constant Torque hose clamps. This I consider
to be a minimum configuration if you are not using -16 AN or -24 AN or
Wiggins couplings for your water plumbing.
It does not pay to save pennies on hose connections as a cheap
hose connection WILL cause you to CRASH sooner or later. Is all
your time building your airplane and money spent on the kit and
engine worth it?
Cheap automotive hoses and simple worm drive hose clamps will not
cut it.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.