Subject: P Port throttle bodies
From: ACRE
Date: 6/12/2004, 6:01 AM


If so! my suggestion would be to step the Throttle Body OD to allow
for 2
O-rings and use two studs to hold the TB in and to keep pressure on
the
O-rings. Perhaps one could use the current stud  and another at the
top.

>From pictures of Richard Sohn's project it would appear  he is using
studs
to retain the TB.

I think I will do it that way if I can.
George (down under)

George,
Using the stepped setup with o-rings is fine. The o-rings do get brittle
with age use the teflon encapsulated ones. I meant a press fit with no
o-rings but
water tight to be sure!
Bill Jepson
 Richard wrote:

George,

yes I am using studs, but the PP insert is all JB Weld fit. This is an easy
way to get the test engine going and not neccesarily the best solution for
the flight configuration. Also, if it turns out that my IO, which is the
same as the LeMans engine had, is too early I will loose the hard point for
the upper stud. Future testing will tell.
BTW, I just finished my test TB.

Richard Sohn
N-2071U
unicorn@gdsys.net
www.gdsys.net/WWWmembers/unicorn/

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.