Subject: P Port throttle bodies
From: ACRE
Date: 6/12/2004, 4:20 AM


If so! my suggestion would be to step the Throttle Body OD to allow for 2
O-rings and use two studs to hold the TB in and to keep pressure on the
O-rings. Perhaps one could use the current stud  and another at the top.

>From pictures of Richard Sohn's project it would appear  he is using studs
to retain the TB.

I think I will do it that way if I can.
George (down under)

George,
Using the stepped setup with o-rings is fine. The o-rings do get brittle with age use the teflon encapsulated ones. I meant a press fit with no o-rings but
water tight to be sure!
Bill Jepson


 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.