Not sure about this Hans,
The airflow through the compressor/engine and thus the boost would be the
same either way. With a TB after the compressor you have a BOV to relieve
the pressure when changing from full throttle to idle. If the TB is before
the compressor, the stress on it would be roughly the same but you would
need a vacuum release valve instead between the TB and compressor. Since the
engine wants to create vacuum when slowing, you might have a slow/delayed
throttle response this way.
Ron Freie
Ron and group,
What is needed is a proper waste gate of course. I would like to add one other
item about having the TB after the compressor. The shafts need to be sealed and turbo size is still important. If you have a large turbo relative to engine
size, the turbo will want to overboost the engine, and when you try to throttle back you will need to almost close the throttle to lower engine rpm. With a
turbo mismatch there is only a small difference between full and 1/2 throttle. when there is high pressure in the manifold it is hard to stop. We had terrible
throttle control problems on the motorcycles using automotive turbos.
GET A GOOD TURBO MATCH AND WASTE GATE.
Bill Jepson
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.