Bill Schertz wrote:
That is what I did, a heater core (new) from a Ford Escort measures 7"x7"
and has straight inlet tubes, and a 5" cooling fan from McMaster Car blows
air through the core to a distribution box.
Bill Schertz
KIS Cruiser # 4045
Nice work Bill. Who built those flanged tubes?
Is the core tough enough to tig weld AN fittings to it?
Paul Lamar
Paul,
It has two tubes ~5/8" Dia feeding the core. I plan to have either an AN or pipe fitting welded on the tubes after I shorten them a little. I think you will have to be careful on torque values, i.e. support the fitting when torquing the nut, but otherwise should be okay.
Bill Schertz
KIS Cruiser # 4045
If left long... long coolant tubes like that can vibrate and crack around the base.
There is a little trick when welding bungs for AN fitting. Machine
flanged bugs on a lathe with as large a diameter flange as possible that will
distribute the normal bending stress and AN fitting tightening torque
over as as large an area of the thin end tank skin as possible. The weld
on bung will looks like a wide brim hat when done right.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.